DewEze Pump 10 gallon per minute, A mount Turolla High Pressure 83012715 Side Port S16mb P12mb.
This is the Pump Only
NOTE TO INSTALLER
Clutches will need a short burnishing period to generate the rated
torque. This is a process of cycling the clutch to slightly wear the friction
surfaces. This allows full contact and maximum magnetic attraction required for
rated torque (or more).
BURNISHING-TO AVOID BURNING OR HEAT DISTORTION, THE FOLLOWING PROCEDURE IS RECOMMENDED: After clutch is installed, run at 1000-1200 RPM. Cycle the clutch on/off at the rate of 10 seconds on - 10 seconds off for a minimum of 50-100 cycles.
- Mount: A
- GPM: 9
- Port: Side
- Shaft: 7/8" Taper
- Bolt: 5/16-24x1
- Rotation: CW
- Material: Iron
- CS Thick: 2-9/16"
- Model Number: 83012715
- CI: 1.28
- Suction H: 1"
- Suction F: 16mb
- Pressure H: 3/4"
- Pressure F: 12mb
- PSI R1: 3000
- PSI R2: 4000
- Seal Kit: 722084
- Shaft Key: 720161
- Front Seal: 722083
- Series: SD
Where It's Used: 700520, 700521, 700522, 700523, 700526, 700527, 700542, 700543